Termékkereső

Kedves Látogatóink!

A manapság tapasztalható komoly Euro - Forint árfolyam ingadozás miatt kérjük Önöket, termékmegrendelés előtt érdeklődjenek munkatársunknál a pontos árképzés érdekében. A webshopunkban lévő termékek árváltozási jogát fenntartjuk.

Megértésüket köszönjük!

Teljes méretű kép megtekintése

ELAC BS 243

Egységár (darab): 0 HUF

Kérdés felvetése a termékről

elac bs243 small 2

ELAC BS 243 - REVUE DU SON Nr.323 - 5 Etoiles/ Recommande

"... frequency response analysis shows they are almost ruler-flat, meaning, they will provide great tonal accuracy and balance, but also low colouration..."

"The ribbon treble unit Elac use is a good example of this, measuring far flatter than dome units, and this gives the BS 243 an unusually even treble characteristic above 4kHz that will almost certainly translate into smooth, clean treble, of exemplary ribbon quality."

"As for the bass? That, if anything, was the surprise package. It was pacey and effective but without strain or boom. "

Hi-Fi World (UK) review

"The loudspeakers are fantastically made and bear the proud sticker ‘Made in Germany’. Advanced engineering and good looks. This is ELAC."

High Fidelity (Poland) review

Technologies: TT150AS-XR, JET III, DC ring (JET Dispersion Control)

Specifications

Dimensions H × W × D

285 × 170 × 220 (232) mm

Gross Volume

11.2 l

Weight

5.2 kg

Principle

2-ways, bass reflex

Woofer
Bass Ports

1 × 150 mm AS-XR cone

1 × 45 mm (with Bass Control Plug)

Tweeter

1 × JET III (mag. shielded)

Recom. Amplifier Power
at Nominal Impedance

30-150 W / channel

Crossover Frequency

2,700 Hz

Sensitivity

87 dB / 2.83 V / 1 m

Nominal Impedance
suitable for amplifiers (from ... to)

4 Ohm
4 ... 8 Ohm

Minimum Impedance

3.6 Ohm / 240 Hz

Frequency Range
acc. to IEC 268-5

41 ··· 50,000 Hz

Nominal / Peak Power Handling

60 / 80 W

Finishes

black high gloss

titan shadow

cherry veneer

mocha veneer

white high gloss

Brochure download

Treble Unit

JET III used in all 240 Series range.

elac jet tweeter 240 series 2

The ELAC JET tweeter is one of the most legendary tweeters in the hi-fi trade and has won international renown with its unusual transparent and effortless sound image.

The JET tweeter was delveloped to perfection on the basis of the famous 'Air Motion Transformer' by loudpseaker pioneer Dr Oskar Heil. Its principle: a concertinaed foil membrane is driven by a strong magnet system of neodymium rods.

This 'motor' drives the air considerably faster than the conventional pistonic technique. High sensitivity and extraordiary dynamics are the result. Due to continuous improvement, the JET III tweeter now creates an effortless and airy resonance-free image up to 50,000 Hz, and with its linear frequency response is ideally suited for the reproduction of DVD-A and SACD.

elac 240 series tweeter 5

elac 240 series tweeter 4

The ELAC "JET Dispersion Control DC" is a flat ring made of open-cell rubber foam which is mounted around the JET orifice with four clasps (or with adhesive tape).

The JET DC results in a broadband reduction of about 0.5 dB of the radiated sound level nearly independent of frequency. The JET DC is best suited for rooms with little sound absorption at high frequencies, especially for rooms with large windows without curtains or with a smooth floor without a carpet.

All loudspeakers of the 240 series are supplied with the JET Dispersion Control as an accessory.

Midbass Unit

TT 150 AS-XR midbass used in: BS 243, CC 241, FS 247 and FS 248.

All woofers and midrange drivers of the 240 series contain the new "Crystal Membrane" (patent pending) and their design is based on the well-known "Aluminium-Sandwich AS Technology" which was developed by ELAC a couple of years ago. The crystal-shaped inverse aluminium dome is joined to the paper cone in a special glueing process resulting the desired sandwich construction.

The stamping of the aluminium foil looks like the surface of a large crystal, this is where the term "Crystal Membrane" come from. This stamping stiffens the aluminium dome considerably which diminishes the membrane-internal resonances resulting in less sound coloration and additionally improves the large signal behaviour noticeably.

The voice coil is not only - like usually - joined to the neck of the paper cone but also to the bottom of the aluminium dome. This design results in the expansion of the transmission range of the respective woofers or midrange drivers by nearly an octave. Therefore the abbreviation "XR" (eXtended Range) has been introduced.

elac tt150as-xr 1

elac tt150as-xr 2

Kosár

Az Ön kosara pillanatnyilag üres.

Kedves Látogatóink!

Szeretnénk értesíteni Önöket, a szombati nyitvatartásunk megváltozott!

Szombaton az előzetesen bejelentkezett érdeklődők függvényében vagyunk nyitva. Amennyiben Önnek kényelmesebb szombaton ellátogatni üzletünkbe, kérjük jelezze az elérhetőségeink bármelyikén.

Köszönjük!